How to Patch Carpet

Is a damaged area on your carpet starting to irritate you? Say goodbye to this small annoyance by replacing that portion with some pieces that you might have left from the installation. Or, cut out some parts from hidden spots using the following tips: 

Mark the area

Use an awl or capped pen to establish a square around the damaged area. Press the instrument into the carpet between the tufts and drag it. This separates the tufts and minimizes the number of tufts that will get cut.

Cut the damaged part

Use your carpet or utility knife to cut the carpet along the lines of the square. Try your best to cut only the backing of the carpet, avoiding tufts. Carefully remove the section of carpeting. If any carpet fibers remain attached, cut them rather than pull them away. Source: TheSpruce

Prepare the carpet patch

Next, cut a replacement plug, using the cutout as a template. To start, make a first cut in the replacement material, using a straightedge to guide your carpet knife. Then set the cutout on the replacement material with one edge aligned along that first cut. When you lay the cutout on top of the replacement material, make sure their naps are running in the same direction. You can tell which direction the nap is running by rubbing your hand over the carpeting and watching which way the fibers fall or stand up. Once you have the cutout lined up correctly, part the fibers around the three uncut sides just as you did before.

Cut along the parts and test-fit the plug in the cutout hole, making sure the nap of the plug matches the nap of the surrounding carpet. If the plug is a little too big, trim off a single row of fibers with sharp scissors (old, dull scissors will tear the fibers). Source: FamilyHandyman

Put the patch in place

Groom away any loose carpet fibers from the edge of the hole. Check the fit before applying any glue. Then, put down a thin layer of carpet glue along the edges of the adhesive disk. Place the patch into the hole, taking care to make sure the fit is snug and even. Press lightly to allow the backing on the patch to come into contact with the underlying tape and adhere properly. 

• Align the patch so that the direction of the fibers in the patch match the direction of the fibers in the rest of the carpet.
• You have about 15 minutes to position and align the patch perfectly before the glue sets, permanently anchoring your patch in place. Work quickly. Source: WikiHow

Are you afraid to mess up this DIY job and end up causing more damage? Let a professional do it for you in just an instant. Call us today to set up an appointment!

The post How to Patch Carpet appeared first on Curlys Carpet Repair.

from Curlys Carpet Repair https://ift.tt/3dCmodu